I'm looking at getting some rv275's in the near future. I'm not going to be running a box but instead i was just gonna get a boost fooler till i can have the extra cash for a Van Aaken or edge box. Where would be a good place to find a boost fooler for my 02? And i know that the 275's on a Etc are about 40 hp but what is the torque they produce? just wondering so i have kind of a rough idea on what my numbers will be. thanks
matt

Try www.haisleymachine.com for a boost fooler. The 275's should give you roughly 75-80 lb/ft torque. Go with an Edge box, or Maro's MAD ECM, both add timing. You will also have to rig your wastegate to allow more boost pressure if you have the factory HY35. :smoke: :smoke:

What Smokem said.

Plus, if you do a timing only box like an EZ, you can add a TST PM3 Comp or a BlueChip Redline later on down the road.

dont waste your time with 275's unless they are free.You'll hardly notice anything at all.Go with something bigger,like a Mach 1-1.5 EDM from Don M,you'' get a real power increase,stronger low end,and a nice mileage gain too,with fuel prices where they are,every bit helps.

What John DiMartino said!

Doug

Yep, John is right on!

:roflmao: So I guess that guy I pulled against this summer who said he had RV275 injectors and dyno'ed 1600 ft./lbs. was really blowing more than just smoke? :roflmao: At least that's what I told him. :poke:

I sure liked my 275's, didnt see much differance just puttin around but foot in it or pulling the Jeep was noticable. :Thumbup:

:roflmao: So I guess that guy I pulled against this summer who said he had RV275 injectors and dyno'ed 1600 ft./lbs. was really blowing more than just smoke? :roflmao: At least that's what I told him. :poke:

Yeah.... I believe he was stretching the blanket a bit.....:roflmao: :roflmao: :roflmao: