Join Date: Jul 2005
Thanked 0 Times in 0 Posts
To make the remote work while the truck is running you will need to look at a wiring diagram and cut the ignition sense wire going to the keyless entry unit. I did this on my 97 right after I purchased it new, if I remember correctly it was a brown wire with a white stripe. Once you look on a wiring diagram and figure out the correct wire just cut it and tape the ends.
97 F-350 cc srw 4X4,White,Cab hi Leer,4.10's,Hypermax H2E turbo,BDP stage 1 injectors and fuel system,BTS tranny and dual HPOP,Banks intercooler,4-pos. chip programmed by Tony Wildman,Joe Servo idm,Tymar intake and hx mod,missing kitty,4" exhaust before rear wheel,Skyjacker 4" system,35" BFG's w/Weld wheels,Amsoil dual bypass filterw/Amsoil syn. oil and diff. lube.