New Scan Gauge release - Diesel Truck Forum - TheDieselGarage.com
Thread Details Posted by killerbee, this thread has received 22 replies and been viewed 3503 times.

Reply
 
LinkBack Thread Tools Display Modes
post #1 of 23 (permalink) Old 06-22-2007, 01:13 PM Thread Starter
BUG JUICER and
 
Join Date: Jul 2006
Posts: 1,239
Points: 24,980
Thanks: 0
Thanked 1 Time in 1 Post
New Scan Gauge release

There are separate Ford Dodge and GM models. They allow you also to scan and clear codes, datalog your runs, and playback, does performance, 0-60, etc. Many capabilities, and is plug and play. Just plug into the obd port, and no wire splicing required.

Each gauge also has inputs for 2 other analog sensors, you scale the signal.

I personally love these for diagnosis. Want to see how effective your "cold" air intake is? IAT does not lie.

A1A-GM Supported Parameters (PID’S)
1. INTAKE AIR- Intake Air Temperature - **
2. COOLANT TEMP- Engine Coolant Temperature **
3. TRANS TEMP 1- Transmission Temperature for automatic gas vehicles
4. TRANS TEMP 2- Trans temp for some vehicles made from ’94-’97.
4. RPM- engine Revolutions Per Minute **
5. MAF SENSOR LB/M- Mass Air Flow (lbs/min) **
6. MAF FREQUENCY- raw Mass Air Flow sensor output (frequency)
7. MAF FREQUENCY 2- raw MAF sensor output for the Cobalt SS and Redline
8. MANIFOLD PSI- Manifold Air Pressure (psi) **
9. THROTTLE POS. PCT- Throttle Position percentage (0-100%)
10. THROTTLE VOLTS- Throttle Position sensor output (0-5 volts)
11. MILES PER HOUR- Miles Per Hour **
12. KNOCK RETARD- Knock Retard (degrees) for most GM vehicles
13. KNOCK RETARD 2- used for KR value of ’94-’97 LT1’s and some 96/97 V8’s.
14. KNOCK RETARD 3- used for knock retard value of the Cobalt SS SC and Redline
15. IGNITION ADVANCE- ignition timing advance
16. PULSE WIDTH- injector #1 pulse width (4&6 cylinder engines)
17. SHORT TRIM B1-short term fuel trim bank#1
18. SHORT TRIM B2-short term fuel trim bank#2
19. LONG TRIM B1-long term fuel trim bank#1
20. LONG TRIM B2-long term fuel trim bank#2
21. OXYGEN SENSOR B1-O2 bank 1 sensor in millivolts
22. OXYGEN SENSOR B2-O2 bank 2 sensor in millivolts
23. RUN TIME MINS- engine run time is tenths of seconds since last engine start **
24. BATTERY VOLTAGE- Alternator/battery output voltage **
25. IAC POSITION- Idle Air Control counts (position of Idle Air Control valve)
26. PULSE WIDTH B1-injector Pulse Width for bank 1 (8 cylinder engines)
27. PULSE WIDTH B2-injector Pulse Width for bank 2 (8 cylinder engines)
28. ENGINE LOAD- calculated Engine Load (0-100%) **
29. ENGINE OIL PRESSURE (some 8 cylinder engines) **
30. INTAKE AIR 2 – Intake Air Temp. downstream of intercooler (some supercharged
applications such as the Cobalt SS, Ion Redline).
31. TRANS TEMP AL- Allison transmission temp, Duramax and Workhorse
32. TORQUE CONVERTER SLIP AL- Allison transmission converter slip, Dmax and WH
33. TQ TO TRANS AL- Engine torque delivered to trans, Duramax and Workhorse
34. INJECTOR RAIL PRESSURE DESIRED DM- Duramax
35. INJECTOR RAIL PRESSURE ACTUAL DM- Duramax
36. THROTTLE PCT DM- Throttle percentage- Duramax
37. THROTTLE VOLTS DM- Throttle sensor voltage- Duramax
38. FUEL LEVEL DM- Duramax
39. INJECTOR FLOW RATE DM- Duramax
40. Miles Per Gallon 1- instantaneous fuel economy for gas vehicles
41. Miles Per Gallon 2- instantaneous fuel economy for diesel vehicles
42. HP 1- Calculated net horsepower for gasoline vehicles
43. HP 2- Calculated net horsepower for diesel vehicles
42. Analog 1 – analog input #1.
43. Analog 2 – analog input #2
44. TOTAL MISFIRES- Total misfires of all cylinders. Resets every minute.
45. BAROMETRIC PRESSURE- limited support on standard GM vehicles, DM support

added some more TD parameters

46. Main inj PW
47. Pilot injection PW
48. Main Timing
49. Pilot Timing
50. Desired Boost
51. Actual Boost
52. Desired Turbo Vane Position
53. Actual Vane Position
54. Desired Fuel Rail Pressure
55. Actual Rail Pressure (diagnose filter clogs)
**These parameters are also supported by the Duramax
Attached Thumbnails
Click image for larger version

Name:	IMG_5606.JPG
Views:	191
Size:	102.6 KB
ID:	10785   Click image for larger version

Name:	IMG_5605.JPG
Views:	166
Size:	80.9 KB
ID:	10786   Click image for larger version

Name:	IMG_5537.JPG
Views:	176
Size:	84.5 KB
ID:	10787   Click image for larger version

Name:	IMG_5600.JPG
Views:	279
Size:	80.9 KB
ID:	10788  

Michael
Vehicle Systems Engineer/Professional Tuner
04.5 GMC 2500HD SRW LLY

Learn about INDUCTION OVERHEATING


ECM's FOR SALE
killerbee is offline  
Sponsored Links
Advertisement
 
post #2 of 23 (permalink) Old 06-22-2007, 09:10 PM
 
Join Date: Aug 2005
Posts: 230
Points: 1,783
Thanks: 0
Thanked 0 Times in 0 Posts
Those sound like some very nice gauges. Do you have an estimated cost for them yet? What year models do they work on, what functions work on what vehicle and is three the most you can have (not that I would need three but who knows)?

Very clean install as well.
QtrHorse is offline  
post #3 of 23 (permalink) Old 06-22-2007, 10:09 PM Thread Starter
BUG JUICER and
Threadstarter
 
Join Date: Jul 2006
Posts: 1,239
Points: 24,980
Thanks: 0
Thanked 1 Time in 1 Post
right now, 2 is the max number that can be run simultaneously on the bus.

Let me know what year/model, and I'll check. Should be good through the last 5 years anyway. just depends

single $239
double $399

Michael
Vehicle Systems Engineer/Professional Tuner
04.5 GMC 2500HD SRW LLY

Learn about INDUCTION OVERHEATING


ECM's FOR SALE
killerbee is offline  
post #4 of 23 (permalink) Old 07-25-2007, 02:12 AM Thread Starter
BUG JUICER and
Threadstarter
 
Join Date: Jul 2006
Posts: 1,239
Points: 24,980
Thanks: 0
Thanked 1 Time in 1 Post
The Ford Gauge will be available early august.
Dodge is on the way also.

The 06 and later duramax gauge will also be shipping in August.

Michael

Michael
Vehicle Systems Engineer/Professional Tuner
04.5 GMC 2500HD SRW LLY

Learn about INDUCTION OVERHEATING


ECM's FOR SALE
killerbee is offline  
post #5 of 23 (permalink) Old 09-10-2007, 11:10 PM Thread Starter
BUG JUICER and
Threadstarter
 
Join Date: Jul 2006
Posts: 1,239
Points: 24,980
Thanks: 0
Thanked 1 Time in 1 Post
New White Face Gauges

for variety. Also the 06,07 Gauges are due out in 2 weeks.
Attached Thumbnails
Click image for larger version

Name:	IMG_0162.jpg
Views:	92
Size:	91.7 KB
ID:	12066   Click image for larger version

Name:	IMG_0156.jpg
Views:	90
Size:	101.6 KB
ID:	12067   Click image for larger version

Name:	IMG_0161.jpg
Views:	98
Size:	90.5 KB
ID:	12068   Click image for larger version

Name:	IMG_0157.jpg
Views:	76
Size:	94.0 KB
ID:	12069  

Michael
Vehicle Systems Engineer/Professional Tuner
04.5 GMC 2500HD SRW LLY

Learn about INDUCTION OVERHEATING


ECM's FOR SALE
killerbee is offline  
post #6 of 23 (permalink) Old 09-10-2007, 11:22 PM
Senior Member
 
Join Date: Jun 2005
Posts: 1,291
Points: 39,785
Thanks: 0
Thanked 1 Time in 1 Post
Send a message via AIM to LIPD
those are very nice
LIPD is offline  
post #7 of 23 (permalink) Old 09-11-2007, 01:16 AM
4cstr
Guest
 
Posts: n/a
Points: 0 [Check]
Are the Ford versions out yet Michael?
post #8 of 23 (permalink) Old 09-11-2007, 01:20 AM
fordt
Guest
 
Posts: n/a
Points: 0 [Check]
Let us know when the '07 guages are out for LBZ, I like seeing a traditional needle guage, but the functionality/practicality of these guages exceeds that.
post #9 of 23 (permalink) Old 09-11-2007, 01:26 AM
Senior Member
 
KT Performance's Avatar
 
Join Date: Dec 2006
Location: Clermont, FL.
Posts: 2,037
Points: 56,694
Thanks: 72
Thanked 107 Times in 100 Posts
Very nice!
KT Performance is offline  
post #10 of 23 (permalink) Old 09-11-2007, 03:23 AM Thread Starter
BUG JUICER and
Threadstarter
 
Join Date: Jul 2006
Posts: 1,239
Points: 24,980
Thanks: 0
Thanked 1 Time in 1 Post
Ford will be here in 2 weeks.

LBZ should be here in a few days. If you want to pre-order, let me know what colors you want, and I will be sure to get them first. Just drop me a PM.

I think they are a hoot, a good compliment to EFILive. I too had to get used to losing the swinging orange needle, kinda like switching to lowfat milk.

Michael
Vehicle Systems Engineer/Professional Tuner
04.5 GMC 2500HD SRW LLY

Learn about INDUCTION OVERHEATING


ECM's FOR SALE
killerbee is offline  
Reply

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the Diesel Truck Forum - TheDieselGarage.com forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode



Posting Rules  
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome