I have a few parts that I am wanting to get rid of. My intentions were to build a 2wd race truck but some other things are coming up and need more attention then a race truck does. So here is the list.
Compound turbo kit
- $5700 Shipped
The kit has a 66mm paired with an 82mm. Both turbos are turbonetics and ball bearing. The 66 is the T-66 series with a F1-68 exhaust wheel and .84 exhaust housing. The exhaust housing ran fine as a single and had very little lag with innovatives tuning. You could tighten it up a bit with a .80 housing because when I ran it as a single I was seeing a 1 to 1 ratio of boost to exhaust backpressure. The 82mm consists of a midframe center section, F1-75 exhaust wheel and the compressor is an 82mm from a Y2K. It was a hybrid unit that turbonetics made. The 66 has maybe 300 miles on it and I don't recall how many miles the 82 has on it but I know its not many because the setup was taken off for a common rail conversion. I myself have never ran the setup but I believe that the way it is currently setup it shouldn't have any backpressure issues like the previous owner had. It has all the piping and a wastegate included. The wastgate is a RG-45 from turbonetics and has the remote adjustment control. There may be a coupler or two missing but that is all.
Elite Diesel 225 cc Injectors
- $1200 Shipped
These should actually flow about 275cc's. They were mislabeled when they were sold and should have been sold as 275's.
Trusted oil filter relocation kit
- $500 Shipped
I know Tim had some issues with his filters so I will sell it with new filters to get rid of the "problems" that he had. This is brand new in box.
Dieselsite HPODS system
- $350 Shipped
This doesn't have the lines because I was going to make them work around the compound turbo kit.
- $250 Shipped
These are torqued once set of headstuds.
- $150 Shipped
Brand new never used.
ATS regulated return system
- $400 shipped
The kit has the rear lines, regulator, and the A1000 fuel pump. It is missing the lines from the fuel bowl to the front of the engine.
- $100 Shipped
Stock tranny pan
- $50 shipped
If you are interested or have any questions email me at [email protected]
or shoot me a PM on here.