The Diesel Garage banner

Looking for a 5.9 or 6.7 bare block in SW TN or NW MS

2K views 0 replies 1 participant last post by  Fastback 
#1 ·
I'm looking for a 5.9 or 6.7 Cummins block to start building on for a project. Need s to at least be in machinable condition with only the spec amount of deck warpage, if any and no crossthreaded bolt holes. I've looked on CL and a few other sites with no "need specific" luck. I've checked some junkyards around here but the dodge trucks they did have were picked clean of anything I would need. I live in Memphis and I'm willing to drive about 100-175 miles which roundtrip is about a tank's worth for me.

Thx in adv! :D :D
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top