Hey guys, I have done exactly what everyone says and shows to do to make a torque converter lockup on my 2000 and it doesnt work?!! Whats causing it not to work? I t'd into the purple wire with yellow tracer and ran it to a toggle switch then made a short wire that i grounded to a bar under the fuse panel in the cab and ran it to the switch also. Still doesnt work. Any ideas? :bang
make sure that you have a good ground and that the connections are good all the way out to the purple wire. I had the same problem when i hooked mine up and found out that my brand new switch was bad.
I tied into it down by the tranny the first time and it didnt work. Than I tied it in up by the airbox and it still didnt work??? So I dont know what it is.
I cant get the lockup switch itself to work. The tc locks up when it is supposed to by the computer
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
The Diesel Garage
1.2M posts
57.3K members
Since 2005
A forum community dedicated to Diesel engine owners and enthusiasts. Come join the discussion about performance, builds, ecodiesel, towing capacity, modifications, classifieds, troubleshooting, maintenance, and more!