Search Results for ‘6.0’

I know it's probably a long shot but figured I would ask anyways. Long story short I had my truck in 4high (towing through mud) afterwards with no trailer hooked up I hit the road in front of my house to knock all the mud off just a couple short launches nothing to bad. Afterwards pulled back...

I know it's probably a long shot but figured I would ask anyways. Long story short I had my truck in 4high (towing through mud) afterwards with no trailer hooked up I hit the road in front of my house to knock all the mud off just a couple short launches nothing to bad. Afterwards pulled back...

I’m looking at buying the FABTECH 6” lift for my 06 2wd DRW F350. It says online that it fits the F250, so I was just curious if it would fit a F350. Thanks in advance!!

Havin trouble guys need help my truck got a 2285 code before it died a week later, took it apart oil cooler was plugged, it used to start if hot outside but not cold,,,did egr delete while in there,replaced oil cooler and gaskets ect, rebuilt ipr, scanguage reads icp good ficm dropped to 22...

Rebuilt ipr 2285 code a week before it died for good, scanguage shows icp is good, put new oil cooler in and egr delete while I had it apart, ficm showed 47 then dropped as low as 23 when cranking,,,need help

Wanted to intro myself my name is Jacob and havin trouble gettin my 6.0 runnin so I'm lookin for advice,,,thanks!

I bought an 07 F350 Lariat Outlaw in June of 2013 so I am fairly new to the diesel world. Looking to get some suggestions on mods and fixes for my truck so I joined this forum.

I am looking at putting my 2 Inch Sinister Diesel leveling kit on. I have heard mixed things about it moving the front axel an inch or two towards the drivers side of the truck. Has anyone installed on of these and had this happen? I want the axle to be prefectly under the truck. Will I have to...

Hey guys, I finally decided to join after reading on your site for weeks on end researching the 6.0 Powerstroke. You all have a wealth of information here! I am still searching for my Excursion. I think I have narrowed it down to a few. Does anyone on here still do OASIS reports if I want...

Looking at a 2005 Excursion. VIN = 1FMSU45PX5EA49464 I would be extremely grateful if someone could help me by running an Oasis report on the vehicle. Thanks in advance, Damon.

Seems that once I find the right truck, it sells before I make the move. I'm ready, just need the oasis to confirm this is the one. Keeping my fingers crossed! Thanks, Don 1FTWW31P06EC54650

I have a 2006 6.0 that cranks for a long time (5-6 secs) after sitting over night. When hot the truck will fire up after 1-2 seconds. Tested the ficm voltage and got 48v. No drop when cranking or running. Any suggestions on what to check? Thanks for the help.

We have a TEC Stage 3 VGT Turbo for an 03-07 6.0 Powerstroke. This turbo will support up to 750 Horsepower. The Stage III/Black Lighting is a 77mm Tubine Wheel with a 66mm inducer/96mm exducer Compressor Wheel and flows 70lb/min at a 2.5 pressure ratio. Also, has a efficiency of 70%. Retail...

Even though I think my 2005 F250 should not be leaking oil with only 66k on the 6.0L, it has marked its territory for the past year in one small spot on the passenger side until a month ago, and now has starting to show drops on the driver’s side...this is a much larger "puddle" (2-3 drops as...

Just went through the typical replacement of the EGR, et al as the truck broke down. I had been experiencing surging at least through the first few gears. The engine rythmically goes up and down by +/- 100 RPMs. Not as noticeable if I just floor the pedal, but still feel it. The local Ford techs...

Hey everyone. This is my first "business" post as opposed to the "greeting" post. Some background... I bought an '05 Ex Lmtd w/ 100K on it last November. I had planned on going thru the truck before using it much but my daily driver broke so I've been using the Ex for about 8K mi. The EGR...

Up for sale is any 6.0 parts you might need,Turbo, fuel pump Long block, Arp head studs (less than 2000miles) I traded a Powerstroke for a cummins, best thing i ever did. Feel free to let me know if you need anything for a 6.0, all of it is cheap!

This is out of the same truck we are doing that 12v conversion into. I have a nearly brand new Edge Juice Attitude, Platinum version for all 6.0 Powerstrokes. It has a manufacture date of 8-5-08. New these run about $875, you can pick this one up for far less. Includes thermalcouple and...

Hey guys, we are doing a 12v conversion into a Superduty. Long story short, I have a 2004 6.0 motor that I need to move. The guy brought the truck in originally with leaky headgaskets. We studded the motor and deleted the EGR. Less than a month later the guy decided he wanted a 12v in it. The...