Search Results for ‘fuel’

I have an 89 F350 Crew Cab Dually with a 7.3 and an A/T behind. My problem is we just put a New Carquest Brand Pickup/Lift Pump on it today and cannot get it to Pump fuel up to the Filter. We removed the fuel line going into the fuel filter and attached a manual vacuum pump to it and using it...

2002 international 4300 with dt466 looking for correct name and part number for fuel regulator on back of head/ fuel rail. the one that return fuel line connects to

So I recently purchased a tow truck for a new business venture. It's a 2002 international 4300. When I purchased it I knew it would need a little work, it sat for a year, steel tank had rust, so the tank was replaced with a aluminum one. the truck ran, but was slugish on hills and had a...

Hey, I just bought a FL80 with a 3126 CAT, It starts and drives fine, after a while it will just shut off, check engine light on/flashing. then it just cranks and cranks with no firing at all. then after an hour or two it pops right off again with no CEL on. There are no active or inactive codes...

I am looking for a different way of being efficient with gasoline. Chainsaws & ATV's are about the only things we have burning gasoline, everything else burns Diesel fuel! The ATV's normally get a little low on the gauge, and the tank will hold a 2 gallon can of fuel. Then commonly refill the...

My dilemma is I let my best friends little brother borrow my 12v because he got a new job and needed a truck temporarily. I drove the truck for 4 years with never having a starting issue. He had the truck for 4 days then calls me and tells me that it wont start. He drove 82 miles on brand new...

pete 359 with cat 3406b at idle if you give it some gas and you let off the peddle all at one time it shuts off but if you let off slowly it will not. it runs out good and has good power under load.. kinda just lookin for some info on where to start?

Hello.to Everyone.I have a 2004 INT. with a VT275,with a no start problem I been testing with "Diamond Logic Controller 2" using a NexQ Usb Link.I ran a hard/no start and found the ICP Desired is 900 psig and the ICP is 65 psig.So I replaced the IPR and top off the engine oil,replaced the fuel...

I have 2001 F250 4X4 diesel PU. It runs fine until I get to about half a tank of fuel. Then it won't run. I know the tank is not empty because when I fill up, it only takes about 15 gallons. Then it runs fine again until it gets down to half a tank. What is wrong?

I have a 1993 International 8300 with a Cummins Celect L10 330hp. Engine stopped running. Traced problem to fuel solenoid not getting any electrical current. Put a jumper wire from a 12 volt source and truck starts and runs. But, with this set up, the engine will cut out while idling...

Hello all... I recently picked up a 1997 IH 4700 with the T444E in it (~110k miles). The truck's "get up and go" is terrible compared with another identical truck that I test drove and it maxxes out at around 63 mph on the flat. I know that IH can program a limiter on the truck for a certain...