The Diesel Garage banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
i just replaced the injector cups on an 03 excursion with a 7.3 in it. we have done the job before and had no problems with starting after. after the job was completed tried starting the truck and will not start. we got it started with a little shot of starting fluid and it will run at idle for as long as u let it. as soon as u touch the accelerator it shuts right off. will not restart on own after it shuts off either. pulled the codes up and got a p1211 and p1212 both injector control pressure codes. any help where to start on this

jamie
 

·
rock removal technition
Joined
·
589 Posts
may be just taking a little longer to get all the air out
 
1 - 3 of 3 Posts
Top