The Diesel Garage banner
1 - 2 of 2 Posts

1 Posts
Discussion Starter · #1 ·
Reason for IPR Replacement:
Truck started to surge and popped a 2290 error code.

Prior to IPR replacement:
Cold start - no issue
Hot start - no issue

recheck connections
ground is connected
replaced in last six months

connection wiring and pig tail look fine.

So, what would cause a no start after an IPR replacement?

I do have new O-rings and screen for the old one.

Not sure if this is important but, I have not refilled the coolant(about 2 gals low) because
I didn't want to have to drain it again if something was a miss.

Thanks in advance.
1 - 2 of 2 Posts