The Diesel Garage banner

1 - 4 of 4 Posts

·
Registered
Joined
·
657 Posts
Discussion Starter #1
My Dad's cv joint went out on his 0'something polaris. It's the back right and making a metal to metal noise. I think he might have mud in his boot instead of grease? Is this a hard job to tackle? He's scared to even start, I toled him I'd come over and tear it apart but don't know if I need any specialty tools? I heard from mechanic you need a clip/ring remover?
 

·
GOT BEER?
Joined
·
164 Posts
It isn't bad at all. I can do it and I am not mechanically inclined.
 

·
Senior Member
Joined
·
377 Posts
No special tools required. There is a ring inside that holds the joint on the shaft. You can not get to it with anything you just tap the joint off the shaft, and thats it.
 

·
In the passing lane
Joined
·
1,195 Posts
If you dont want to tackle the project take it to you local 4 wheeler dealer.
 
1 - 4 of 4 Posts
Top