The Diesel Garage banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I've been looking all over the internet and I cannot seem to find any dimensions of this engine. Can anyone help me out
 

·
Junior Member
Joined
·
19 Posts
I pulled out a 1693 and put a 3406 in its place many years ago, I remember the front motor mount needed to be about 4 inches further back for the 3406 (I actually found found the front mount for the 3406 used since both engines were available in that year Peterbilt) and the bellhousing mounts were in the correct position; I did not have to move them.

Everything else was the same as far as I can remember but it has been a few decades, I don't know if that helps but I junked the 1693 years ago so I can't measure it ;)
 
1 - 2 of 2 Posts
Top