The Diesel Garage banner

Cummins sawp into 03 F250 with a 6.0l

2650 Views 5 Replies 4 Participants Last post by  fsuperduty
Hey guys i am new to the forums. I have a 03 f250 with a 6.0 and a torqueshift.
I been doing quite a bit of searching but i can find out weather i need to cut my drive shafts or not. I am planning on dropping in a cr with a 48re and using my ford transfer case. Any help will be great. Thanks in advance guys.
1 - 1 of 6 Posts
Look at or they can help you out with lots of parts.
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.