The Diesel Garage banner

1 - 9 of 9 Posts

·
Senior Member
Joined
·
560 Posts
Discussion Starter #1
I sold my 2004.5, have some things left over...

Set of four OE aluminum wheels, 17x8.5ish, 8x6.5 pattern (these have tires on them) - $300 OBO (pickup only)

Dynatrac Parts - all new:

Stub Shaft - Cost nearly $200 from DynaTrac. $125 shipped.​
U-Joint Shims - $10 shipped.​

Set of wheel bearings and races - $50 shipped.​

Set of the Warn dials - $50 shipped.​

Velvet-ride shackles (not from this truck) - $100 shipped.

Early 3rd gen tail lights, good condition - $50 shipped?

CRD exhaust manifold, drilled for pyro - $100 plus shipping?

Big Bob's CB mount - $25 shipped?

Two used FCA - $30 each shipped. I bought new ones each time I was chasing issues, it was never a FCA issue (go figure).

Two cam/crank sensors - $10 each shipped. Again, bought to chase issues that were not sensor related; these are the OE that came in my 04.5.

A fuel tank connector to hose barb...this is the little deal that connects to the top of the tank (quick connect) and has a barb for 3/8" hose. $10 shipped.

Complete set of exhaust manifold gaskets (steel), including the manifold to block and the manifold to turbo. $30 for the set shipped? Not sure what a new set goes for?

Complete set of used injector lines, off my truck - $25 for the set shipped?

BullyDog Outlook pillar mount, with a Granatelli monitor (non-working, parts?) - pay shipping?

12 Quarts of Red Line MTL (this is one of the synchromesh alternatives for the NV5600) - no shipping, this runs around $12/quart from Summit; asking $100 OBO.


All this is located near Reading, PA.
 

·
Senior Member
Joined
·
560 Posts
Discussion Starter #4
Responded to PMs.

Prices are best offer...make me an offer, you might be surprised.

I should have indicated this up front, but I don't do paypal...check or MO.
 

·
Senior Member
Joined
·
560 Posts
Discussion Starter #5
Big Bob's Mount and Velvet-Ride Shackles have been sold....
 

·
Senior Member
Joined
·
560 Posts
Discussion Starter #6
 

·
Senior Member
Joined
·
560 Posts
Discussion Starter #7
Back to the top...

Also have a FASS 95/150 with a bad motor (works intermittent, blows fuses) - asking $100.

Have four or five HF6604 filters for the 95/150...these run about $75 from Cummins, asking $35 each.
 

·
Senior Member
Joined
·
560 Posts
Discussion Starter #8
Wheel and tires sold...

I will consider offers on any of it...its not really doing me a lot of good sitting here.
 

·
Senior Member
Joined
·
560 Posts
Discussion Starter #9
Back to the top...again, make an offer.
 
1 - 9 of 9 Posts
Top