[ricardo.rod90]

Yeeeh, I was leaning this direction too. 360* / 32 =11.25*



Is this one?

Other view

Nothink there. this is how it looks from the other side.

On another hand, What is this. Looks like some kind of ajastment posibility?

When you un install the fuell pump you wil see a pin that alines with a mark on the pump gear the hole on the time cover on the side were the fuelpump gose is to chek that the mark on the gear and the pin are aligne be fore uninstaling the pump

 

[ricardo.rod90]

When you have them alingn yo will see that the dame pin is going to be on a mark see pick below

 

[ricardo.rod90]

If You all ready have the fuel pump of and you dont Know how to get the timeing you will need to check the btdc or valle traslap on cilinder 1 to verify that timing is correct move the damper pulley to were the piston is compresión the aire on cilinder 1 and see if the damper pin is on the .mark of the damper pulley and you se that that is the was to verify your timeing