The Diesel Garage banner

1 - 7 of 7 Posts

·
Senior Member
Joined
·
154 Posts
Discussion Starter #1
im looking for a T pipe and mabey some 90 elbows 5"...thanks
 

·
Senior Member
Joined
·
154 Posts
Discussion Starter #3
well i have the set up to run on 6 inch stack, i just need the T to run over the other side of the bed
 

·
Registered
Joined
·
3,353 Posts
Are you wanting to put the stacks in the corner of the bed, or did you have something else in mind? Reason I ask is you can go through one of my distributors, and pick up our y-pipe and long elbow. That way you go across the bed all the way. If thats not what you have in mind we also have universal Y-pipes my distributors can get ya.
 

·
Senior Member
Joined
·
154 Posts
Discussion Starter #5
well see what i have right now is just 3 elbows going to one stack..im wanting to put the y pipe and run exhaust to the other side to have two stack....i beleive i have enough 5'' pipe to run over to the other side, just need the y pipe
 

·
Registered
Joined
·
3,353 Posts
Ok, Y-500A (with plate) Y-500NPA (No Plate) both of these are aluminized, with a 5" inlet thats I.D., and the out lets are 5" O.D. You'll have to buy this from one of my distributors, I can email you a list of them if you'd like.
 
1 - 7 of 7 Posts
Top