The Diesel Garage banner

1 - 8 of 8 Posts

·
riding in the dirty dozen
Joined
·
184 Posts
Discussion Starter #1
well i put in my pyro i did it about 2 to 3 inches about the turbo flange. but im pretty such i got darn lucky cuz i think im RIGHT next to the wall inside of the pipe. now is this going to give me a messed up reading or what. i have it centerd from top to bottom.:shrug:
 

·
Super Moderator
Joined
·
3,190 Posts
It may be a little less accurate, but should still get you close to the correct reading.
 

·
Registered
Joined
·
2,838 Posts
well its still better then in the downpipe
 

·
riding in the dirty dozen
Joined
·
184 Posts
Discussion Starter #4
true. i just wanted to know if it would decipate heat differently or not??
 

·
Registered
Joined
·
2,224 Posts
I don't think that you'll be off any more than 50*. I wouldn't worry about it.
 

·
Senior Member
Joined
·
713 Posts
Years back, I drilled my stock manifold right in the center.:damnit I was like, how thick is this stupid thing? Once I realized what I had done, I had a perfectly centered egt probe, measuring the front and rear manifold egt's.LOL LOL :damnit I didnt run it for too long before I got a good manifold.

Mikey
 

·
riding in the dirty dozen
Joined
·
184 Posts
Discussion Starter #7
lol......thats what i was thinkin when i was doin it....i was like DAMN! please dont tell me i hit the middle!
 

·
Registered
Joined
·
2,838 Posts
ehh its all good, now you got an excuse to get a ATS or HTT 3 piece manifold that comes pre-tapped for a probe:Thumbup:
 
1 - 8 of 8 Posts
Top