The Diesel Garage banner

1 - 5 of 5 Posts

·
Registered
Joined
·
135 Posts
Discussion Starter #1
Ok, so I've got me new(new to me) truck and new challenges. I have a typical bed tool box that straps across the bed behind the rear window. It has a latch to open on each side and a lock. Well being a keyless type of guy, has anyone hooked up an elec. solenoid inside to allow both sides to unlock or lock via the interior door lock switch??? this way when I exit the truck and lock the doors, it will look my tool box as well.
 

·
Senior Member
Joined
·
3,514 Posts
I haven't heard of anyone doing that, But I must say thats a pretty trick idea. It probably wouldn't be too hard to make either.
Sean
 

·
Registered
Joined
·
135 Posts
Discussion Starter #3
Well I did find these Electric solenoids, off ebay. I just need to fab up a bracket and loop for them to lock into.... I wouldn't think this is a new idea. but by response on this and anther board you would think so.
 
1 - 5 of 5 Posts
Top